For more information visit:
www.EatonElectrical.com
Commissioning
MN05013005E
102
Configuring the interface for
the COM-LINK mode
If you wish to set up point-to-point communication with
another station, this can be done using either the serial
interface or EZ-NET. The EZD must be provided with a
display and operating unit. The connection must be
configured for this purpose (Page 348
Proceed as follows:
X
Connect both stations together.
Only use original connection cables. The connector marked
POW-Side must be plugged into an EZD. The EZD feeds the
interface electronics of the connection line at both ends.
X
Connect both stations to the power supply.
Figure 74: Example with both COM stations.
The EZD is the active station and the second station is the remote
station.
X
Switch on the power supply at both stations.
X
Ensure that the power supply for both stations is switched
on. The POW LED must light up or flash. It is only possible
J
Ensure that the other station supports the COM-LINK
mode.
POW-Side
