E-Mu Ultraproteus, Operation Manual

Page: 113 / 307

77 Chapter 7: Preset Programming
PRESET PROGRAMMING
The jumps are called Conditional Jumps because they only jump if a certain
condition is met. For example, the function generator can be programmed to
jump to another segment only if the key is still being held. Otherwise it will
continue on to the next segment. Each of the eight segments can have a condi-
tional jump to any segment (including itself).
Conditional Jumps can be programmed to jump to the destination segment
immediately or they can wait until the end of the current segment before jump-
ing. The possible conditional jumps are as follows:
Never ............................ Never jumps. Always goes on to next segment.
Always End ................. Always jumps at the end of the current segment.
Note On End ............... Jumps at the end of the segment if the note is still on.
Note On Immed. ......... Jumps immediately if the note is still on.
Note Off End ............... Jumps at the end of the segment if the note is off.
Note Off Immed. ........ Jumps immediately if the note is off.
LFO 1 or 2 End .......... Jumps at the end of the segment if the value of the
selected LFO is equal or greater than the
conditional value.
Footsw. 1-3 End ......... Jumps at the end of the segment if the selected Foot-
switch is pressed.
Footsw. 1-3 Immed. ... Jumps immediately if the selected Footswitch is pressed.
Velocity End ................ Jumps at the end of the segment if the velocity value is
greater than a positive conditional value or less than a
negative conditional value. See below.
Key End ....................... Jumps at the end of the segment if the note value is
greater than a positive conditional value or less than a
negative conditional value. See below.
FUNC GEN F1S1
CondValue +064
FUNC GEN F1S1
CondValue -064
A CONDITIONAL JUMP ALWAYS
GOES TO THE BEGINNING OF
THE DESTINATION SEGMENT.
REMEMBER TO TURN UP THE
LFO AMOUNT WHEN USING
LFOS AS CONDITIONALS.
When the value is Positive , a jump
occurs if the velocity or key number is
Greater than value shown.
When the value is Negative , a jump
occurs if the velocity or key number is
Less than value shown (ignoring the
sign).