Dynapac PL2000S, Operating Instructions Manual

Page: 91 / 228

D 31
D PL2
000.
G
B
31
-168
-
1
0
.0
1
Pos. Designation Short description
44
Levelling function,
left
Three switch positions can be selected :
-
0 : Levelling OFF
- AUTO : Levelling engages automatically when
the control lever for the travel drive is fully
extended (milling mode)
- 1 : Levelling ON
Levelling active, responds regardless of the
control lever (primarily for service mode)
LED above the key indicates which device is
connected to the Levelling unit: LED on =
slope controller, off = height controller
At the touch of a button, the system switches
between functions 0 and AUTO, When the but-
ton is pressed down for an extended period,
function 1 is activated.
The engaged function is confirmed by LED.
45 Raising vehicle
While the button is being pressed, all traction units
are extended continuously until they reach their limit
position.
When this function is active, levelling, the mill-
ing drum drive, water sprinkling and the con-
veyor belts are disengaged.
46
Lowering the vehi-
cle
While the button is being pressed, all traction units
are retracted continuously until they reach their limit
position.
Levelling is disengaged automatically during
this function.
47
Raising front left
side of vehicle
While the button is being pressed, the front left trac-
tion unit is extended continuously until it reaches its
limit position.
When this function is active, levelling is disen-
gaged automatically on the left side.
48
Lowering front left
side of vehicle
While the button is being pressed, the front left trac-
tion unit is retracted continuously until it reaches its
limit position.
When this function is active, levelling is disen-
gaged automatically on the left side.