Dynapac PL2000S, Operating Instructions Manual

Page: 220 / 228

D 160
D PL2
000.
G
B
16
0-
16
8 -
10.
0
1
Once all the preparations for milling are complete, the machine is ready for milling,
the automatic levelling device is activated from the main control panel and the ma-
chine is lowered to the depth required while at a standstill.
- Release control lever (14) by pressing slide switch (15) and gently slide forwards
out of central point (within dead band range).
- At the same time, use the function key (9) of the rear side control unit control down
so that the machine dips into a horizontal position and in its final position is tilted
slightly more at the rear than at the front.
This milling position should be retained during the entire milling process, even if the
grading depth is changed via the digital controller.
- Set the milling speed required by pressing button (26) or (25).
The machine starts to move.
- Depending on the setting, the speed display (24) lights up.
The speed reached is shown on the display.
Other settings can also be made on the levelling equipment.
Milling operations using set-up button
If the machine is fitted with two operating panels and equipped for simultaneous op-
eration, the set-up button (39) then assigned the function task can be used to simply
lower the machine when stationary.
Milling drum, automatic levelling device and all other automatic functions needed for
milling operations must be activated in advance.
The simultaneous control lever need not be used to lower the machine in this function
so that the risk of forward motion can be ruled out.
Once the grading depth and position required has been reached in this way by acti-
vating the set-up button (LED active), release one of the two control levers and slide
forwards (LED of set-up button (39) is deactivated).
The machine begins to move forwards and all preset automatic functions are activat-
ed.