Dynapac PL2000S, Operating Instructions Manual

Page: 177 / 228

D 117
D PL2
000.
G
B
1
1
7
-168
-
10
.0
1
Item. Designation Brief description
1
Liquid crystal dis-
play Display can be easily read, even when the light is
poor, thanks to the integrated lighting.
2
Function lamp
"AUTO"
Three operating modes are available:
-
Lamp off: Stand by position - direct adjustment of
grading depth and slope possible in manual
mode. The display indicates the nominal value
selected.
- Lamp on: Machine operating in automatic mode
(automatic mode has been activated on the main
operating panel). The display indicates the
nominal value selected.
- Lamp flashes: Machine operating in semi-
automatic mode (stand by position or pre-
settings for grading depth/ slope possible). The
display indicates the actual value of the grading
depth adopted.
3
Direction lamp
"LEFT"
The direction lamp is a special function for wire
cable sensing with Sonic-Ski (
&
). When using
ground sensing, the lamp is of no significance.
Three operating modes are available:
-
Lamp off: sensing cable running centrally.
- Lamp on: sensing cable running slightly offset.
- Lamp flashes: sensing cable running outside the
measurement area, correction required
$
If the lamp flashes, bring Sonic-Ski back into
central position. If the second direction lamp
flashes at the same time, an alarm has been
activated. If the alarm is activated, an immedi-
ate correction is required! If necessary, inter-
rupt the milling process!
4
Direction lamp
"RIGHT"
The direction lamp is a special function for wire
cable sensing with Sonic-Ski (
&
). When using
ground sensing, the lamp is of no significance.
Three operating modes are available:
-
Lamp off: sensing cable running centrally.
- Lamp on: sensing cable running slightly offset.
- Lamp flashes: sensing cable running outside the
measurement area, correction required
$
If the lamp flashes, bring Sonic-Ski back into
the central position. If the second direction
lamp flashes at the same time, an alarm has
been activated. If the alarm is activated, an im-
mediate correction is required! If necessary,
interrupt the milling process!