Dynapac PL2000S, Operating Instructions Manual

Page: 111 / 228

D 51
D PL2
000.
G
B
51
-168
-
1
0
.0
1
Sprinkling screen
The following settings can be
made from this screen.
- Water volume (F3)
- Reduced water volume (F)
- Run-on time for sprinkling
(F5)
If the vehicle is not in for-
wards travel mode while the
milling drum is turning, the
control unit automatically re-
duces the volume of water af-
ter a preset run-on time. A
reduced volume of water is
sufficient for cooling purposes. If the control lever for the travel drive is fully extended,
the system switches back to the higher water volume setting.
The setting screen is called
up by pressing the appropri-
ate function key:
When setting the water vol-
ume, a large drop of water
flashes. When setting the re-
duced volume of water, a
smaller droplet flashes.
When setting the water vol-
umes, adjustment is made on
a percentage basis.
With the run-one time setting,
the units are measured in
seconds.
- Set the value desired, using the plus / minus buttons, cursor buttons or the numer-
ical keypad.
- You can choose to save, or not save, the amended value by pressing the relevant
function key.
Terminal2.Tif/ Watermask1.jpg
Terminal2.Tif/ Watermask2.jpg