Dynapac PL2000S, Operating Instructions Manual

Page: 144 / 228

D 84
D PL2
000.
G
B
84
-168
-
1
0
.0
1
Pos. Designation Short description
11
Raising the mold-
board
While the button is being pressed, the moldboard is
raised continuously until it reaches its limit position.
Danger resulting from raised loads. Do not en-
ter the danger area.
12
Selector switch
Moldboard
Two switch positions can be selected :
-
0 : Moldboard blocked
-
Ý
: Moldboard in float setting
(applied load function or relief)
The engaged function is confirmed by LED.
During profiling operations the moldboard
should always be in its float setting. Under cer-
tain working conditions, it is however possible
for the moldboard to dig into the substrate.
This problem can be averted by using the
blocking function. This can be prevented
through the use of the blocking or relief func-
tion.
13
Lowering the
moldboard
While the button is being pressed, the moldboard is
lowered continuously until it reaches its limit position.
$
The moldbord may raise the machine.
14
EMERGENCY
STOP button
Press in emergencies (people in danger, risk of colli-
sion etc.)
-
The engine, drive units and steering are
disengaged whenever the EMERGENCY STOP
button is pressed.
No movement, e.g. of the lower conveyor, is then
possible! Risk of accident!
- Before the engine can be restarted, all
EMERGENCY STOP buttons must be raised.
15 Retaining tab
Secure and padlock operating panel housings
at the end of work or during transport opera-
tions!