Dynapac PL2000S, Operating Instructions Manual

Page: 208 / 228

D 148
D PL2
000.
G
B
14
8-
16
8 -
10.
0
1
Checklist for machine operator
Once the maintenance and checking work listed in the maintenance manual has been
conducted at the specified intervals, the inspections and control work listed in the fol-
lowing list should also be noted and conducted.
This work is used to assess the machine status and to assure perfect operations as
well as personal safety.
If permitted by the operations in question, the checks should be conducted before,
during and after use.
Any defects found should be rectified immediately in compliance with the safety reg-
ulations.
Check! How?
Emergency-stop button
- on main control panel
- on the side control units
Check with engine running:
Engine must shut down immediately
after actuation.
The button engages and must be pulled
out so that the engine can be started
again.
Warning signal and warning information
via display indicator
Horn
- on main control panel
- on the side control units
Briefly press horn knob.
Horn signal must sound.
Reverse travel warning device
Check with engine running.
Acoustic signal must sound during
reverse travel.
Lighting
-
Operating headlight
- Rotary beacons
- Hazard flasher
Lights must function,
keep headlight glass clean.
Steering system
Check with engine running:
Machine in straight-ahead travel posi-
tion, steering system responds in sync
with the steering lever adjustment, uni-
form steering locks in all steering vari-
ants (when in co-ordinated steering
mode and in crab steering mode, the
rear axle does however respond with a
slight delay).
Precise straight-ahead position of front
and rear axle once the appropriate func-
tion keys have been pressed.