Dynapac PL2000S, Operating Instructions Manual

Page: 45 / 228

C 1
C PL2
000.
G
B
1-
16
-
10.
01
C Transport
1 Safety regulations for transport
$
There is a risk of accident if the machine is prepared incorrectly and transportation is
conducted incorrectly
Prepare the machine ensuring that all components are secured and cannot come
loose. Dismantle all protruding and removable components and/or fit them so that
they do not represent a hazard!
The weather protecting sun roof should be deployed and appropriately fastened dur-
ing transport.
Lower all of the machine down to the upper section of the separated traction unit sup-
ports. When in this position, the cutting tool tips of the milling drum are approx. 1 cm
above the ground. If a wooden support is fitted, the milling drum can rest gently on
this.
The upper conveyor should also be moved into its floating position if necessary.
The machine should be fastened onto the attachment points provided for this purpose
and fixed to the transporter in accordance with the relevant regulations.
Ensure that the transport vehicle is authorised for transport of this type and that the
maximum transport load is not exceeded.
Store all components which are not permanently connected to the machine in the
boxes and storage areas provided.
Close all panels and check that they are securely fastened.
Use the cover to secure the main control panel, close the side operating units.
When loading via ramps, there is a risk that the machine will slip, tilt or overturn.
Drive carefully! Keep people away from the danger area!
The following applies in addition to the above during transport on public roads:
The machine driver must have a valid driving licence for this type of vehicle.
The operating panel must be on the side facing oncoming traffic and be secured in
place.
The headlights must be set in accordance with the relevant regulations.
When driving on public roads, if necessary, another person must guide the machine
driver – especially at crossroads and side-road junctions.
Note the load bearing capacity of vaults and bridges as well as the permissible trans-
port height and width.