Dynapac PL2000S, Operating Instructions Manual

Page: 213 / 228

D 153
D PL2
000.
G
B
15
3-
16
8 -
10.
0
1
External starting (starting aid)
If the batteries are flat and the starter is
not turning, the engine can be started
using an external source of power.
The following are suitable as sources of
power:
- another vehicle with a 24 V system;
- additional 24 V battery;
- starting aid, 20V/100A.
$
Normal charge devices and rapid charge
devices are not suitable as starting aids.
To externally start the engine:
- Use appropriate cables to connect up
source of power.
$
Check correct polarity! Always connect
the negative cable last and remove it
first!
- Insert ignition key (3) in position "P" in
the ignition.
- Switch on ignition (pos. 1).
Start screen appears on display, posi-
tion diodes of main operating panel light
up.
- Wait until the non-board computer has
booted up ("BOOT" displayed on start
screen (4)).
- Once the booting procedure is com-
plete, the main screen (5) appears on
the display.
- Turn ignition key into pos. 2 to start the diesel engine.
- Once the diesel engine has started, release the ignition key.
- The ignition key automatically jumps back to pos.1.
Once the engine is running:
- disconnect external source of power.
When using starter aid spray, note the engine’s Operating instructions.
Pult2new_a.tif/Terminal2.tif/Bootmask1.jpg/Mainmask1.jpg
3
4
5