Dynapac PL2000S, Operating Instructions Manual

Page: 79 / 228

D 19
D PL2
000.
G
B
19
-168
-
1
0
.0
1
Pos. Designation Short description
15 Slide switch
Used for electrical locking / unlocking of the travel
drives.
To unlock, the switch must be slid forwards.
When unlocking, the switch slips back into its neutral
position once released.
Each time the control lever is pulled over the zero
position, the travel drives are locked again. If the
machine’s direction of travel is to be changed, the
slide switch must be pressed again.
When pressed, the drive is unlocked for 5 seconds
and the engine speed increased.
16 Horn
Use when danger threatens and as an acoustic sig-
nal when setting off!
17
Button for "Crab
steering"
Setting for drive mode of track drives.
Front and rear drives are powered simultaneously.
The engaged function is confirmed by LED.
The function can only be activated with a delay
(approx. 1 minute after program start).
18
Straight-ahead
travel on front
and rear drive units
All drive units are swivelled from their present steer-
ing position into the straight-ahead position.
The machine is then only steered by the front axle.
The function can only be activated with a delay
(approx. 1 minute after program start).
19
Steering
rear drive units
The drive units are swivelled to the left for as long as
the button remains depressed and remain in the
position reached once the button is released.
If this function is engaged, steering mode is
deactivated.
20 Position diodes
Indicate the present position of the front and rear
drive units.
The function can only be activated with a delay
(approx. 1 minute after program start).