49
e03_dv40_7e.fm
Phone/Videophone
Continued on next page
??
1
In stand-by, dial the phone number starting with the area code.
Always dial the area code, even when the number is in the same area.
Enter up to 80 digits for phone number. When the number exceeds 13 digits, it
appears on two lines. When the number exceeds 26 digits, the last 26 digits
appear in two lines.
When a mistake is made while dialing, press
c
to erase the last digit. Press
c
for 1+ seconds to delete all digits and stand-by reappears.
Refer to P. 58 when making an international call.
2
Press
s
[Phone]/
i
[V.phone].
Outgoing calls of
Videophone
When name and
still picture are
saved in the
phonebook
Unlike ordinary telephones, mobile phones send call tones in short beeps before
the standard ring tone.
Phone number and name appear if saved in phonebook. Image also appears if
set in advance.
When the other party is busy, there is a busy signal. Press
H
to disconnect and
try again later.
When a guidance message plays requesting the caller ID, the other party has
set Caller ID Request to
Activate
. Set the caller ID and make a call again.
(
n
P. 46, P. 57)
Voice calls
Calling
appears while calling.
h
appears in the upper part of the display during a call.
Videophone calls
Dialing videophone
appears while dialing.
Refer to “Viewing the Screen During Videophone Calls” on P. 48 for view types
during a Videophone call.
3
Talk when the other party answers the phone.
Videophone
Press
C4
during a voice call and
Cr1
during a Videophone call to view
your phone number.
Videophone calls
The following operations are available during a Videophone call.
4
Press
H
to end the call.
Note
During a call, approximate call duration appears on the screen. When the call duration exceeds 9:59:59, the
display resets to 0:00.
The FOMA terminal may become warm after continuous use. This is not a malfunction.
Do not cover the internal antenna area when making a call.
Close operation is followed if the handset is switched to the viewer position during a call.
Voice calls
Calls can be made even when steps 1 and 2 are reversed. If no operations are performed for five seconds
after dialing, the call is made.
Mobile phone
Enter other party’s number (090-XXXX-XXXX,
080-XXXX-XXXX) (11 digits).
PHS
Enter other party’s number (070-XXXX-XXXX) (11 digits).
To send a substitute image during a
Videophone call
i
The still picture or Chara-den set as
substitute image appears. (
n
P. 77)
To send
touch-tone signals
<DTMF mode>
While sending
camera image
Enter numbers to send
While sending
Chara-den
C7
→
1
→
enter numbers to send
dv40̲e.book 49 ページ ２００６年１０月１１日 水曜日 午前８時３１分
