43
e02_dv40_7e.fm
Before Using the FOMA Terminal
Before turning the power on, check that the FOMA card is properly inserted. (
n
P. 35)
If the FOMA card is not inserted,
Insert UIM
and a FOMA card error appears. (
n
P. 29)
Power ON/OFF
Turning the Power On and Off
Turning the Power On
1
Press
H
(Power) for 2+ seconds.
The wakeup screen appears followed by the initial settings screen. Proceed to
initial settings (
n
P. 44). If initial settings are not yet completed, the setting
screen appears every time the power is turned on.
If initial settings have been completed, the screen shown
on the right appears when power is turned on. This screen
is called the
stand-by display
.
When
Enter PIN1 code
appears, enter the PIN1 code
(
n
P. 150).
When
A
(Out of service area) appears, the handset is
outside the service area or in a place with no signal. Move
to a place where the icon disappears.
Note
When a FOMA card is replaced with a new card, the terminal security code (four to eight digits) must be
entered after turning on the terminal. If a correct terminal security code is entered, stand-by display appears.
When a wrong
terminal security code
is entered five times, the power is turned off. (However, turning on
the power again is possible.)
Turning the Power Off
1
Press
H
(Power) for 2+ seconds.
It may take some time for the power to be turned off. (The end screen appears on the display until the
power is turned off.)
Note
Before connecting to an external device, make sure that all transmissions are complete and then turn off the
FOMA terminal.
Stand-by screen
dv40̲e.book 43 ページ ２００６年１０月１１日 水曜日 午前８時３１分