DKL L2-S300, Operating Instructions Manual, Page: 272 / 327

7117100018L30 1712V002
21
Operation
13 Replace the amalgam
collector vessel
WARNING
Risk of contamination if the amalgam
collector vessel is reused since the
collector vessel is not water-tight.
i
Do not use the collector vessel more
than once (disposable item)�
Wear protective equipment to avoid any
risk of infection (e�g� liquid-tight pro-
tective gloves, protective goggles, face
mask)�
We strongly recommend that the amal-
gam collector vessel should only be
changed in the morning before the start
of work� This will prevent fluid from drip-
ping out of the drum while it is being
changed�
i
Disconnect all power from the device�
i
Remove the full amalgam collecting container
and from the device�
i
Pour disinfectant for suction units (e�g� Orotol
plus, 30 ml) into the full amalgam collector
vessel�
i
Close and secure the full amalgam collector
vessel using the cap� Observe the markings
on the cap and on the collector vessel�
i
Place the securely closed amalgam collector
vessel into its original packaging and seal�
i
Insert a new amalgam collector vessel in the
unit and clamp it in position� Only use original
amalgam collector vessels�
i
Switch on the power supply� The device is
ready for operation again�
12.3 Once or twice a week before
the midday break
Under harsher conditions (e�g� hard water
or frequent use of prophylaxis powders)
1x daily before the midday break
The following are required for cleaning:
– Material-compatible, non-foaming special
cleaning agents that have been approved by
Dürr Dental, e�g� MD 555 Cleaner
– Unit care system, e�g� OroCup
i
To pre-clean, suck up 2 litres of water with the
care system�
i
Aspirate the cleaning agent with the care
system�
i
Rinse with ca� 2 l water after the application
time�
EN