DKL L2-S300, Operating Instructions Manual, Page: 27 / 327

27
Starting the Turbine (Advanced Air)
Starting theTurbine
> Remove the turbine from the instrument holder:
> Activate the start signal at the foot controller
1
.
> Put the turbine back into its holder.
> The last coolant settings are saved.
Air drive system for dental handpieces and dental air motors intended for general
dental use. Removal of carious material,preparation of cavities and crowns, removal
of fi llings, fi nishing oftooth and restoration surfaces.
Full functionality is only possible with the W&H Primea Advanced Air Turbine. If
another turbine or another instrument is plugged on, the Advanced Air works in
standard turbine mode.
Plugging on the Roto Quick coupling and turbine (see also operating instructions of
W&H Dentalwerk Bürmoos GmbH Primea Advanced Air).
Setting the speed
> Activate the speed on the touchscreen
9
.
Decrease / increase (setting range 60,000 to 320,000 rpm)
> Activate the start signal at the foot controller
1
.
> Place the Advanced Air turbine in the instrument holder.
> The last settings are saved
> Remove the Advanced Air turbine from the holder.
> Activate programme confi guration on the touchscreen
10
.
Power
Tactile
In the „Power“ mode, the set speed is kept constant, even under increasing pressure
on the rotating instrument, thus increasing the removal rate.
The „Tactile“ mode allows a reduction of the removal rate under increasing pressure
on the rotating instrument.
My Favourites - Program confi g
Activate programmes (up to 6 programmes possible)
> Activate program confi g.
back