Operating the SA7x
4.3 Applying Power to the SA7x Enclosure
Figure 4–2 SA7x Enclosure Rear Panel
PORT A
SILK SCREEN
PORT B
SILK SCREEN
SDI INTERFACE
CONNECTOR
PORT A
SDI INTERFACE
CONNECTOR
PORT B
REAR
BULKHEAD
REAR
COVER
MOUNTING
SCREW
MOUNTING
SCREW
OVER-
TEMPERATURE
INDICATOR
(BEHIND PANEL)
LINE VOLTAGE
SELECTOR SWITCH
(BEHIND PANEL)
MASTER
ON/OFF
SWITCH
LINE VOLTAGE
CONNECTOR
POWER
SUPPLY
TABS
CXO-2658C
4.3 Applying Power to the SA7x Enclosure
CAUTION
Before applying power to the SA7x enclosure, ensure that the Line
Selector Voltage switch on the enclosure, located behind the SA7x rear
panel, is set to the proper line voltage. Otherwise, you will damage the
power supply. (See Figure 4–2.)
To apply power to the SA7x enclosure, use the following procedure:
1. Verify that the Master On/Off switch on the power supply is set to off.
2. Verify that the drive power switches are set to off (switch button released).
4–6 Operating the SA7x
