Dell POWERCONNECT 5524, User Manual

Page: 375 / 728

Dell PowerConnect 55xx Systems User Guide
375
– Flow Sampling Average Sampling Rate(1024–1073741823) — If x is
entered, a flow sample will be taken for each x frames.
– Flow Sampling Receiver Index — Select one of the indices that was
defined in the sFlow Receivers Settings pages.
– Flow Sampling Maximum Header Size (20–256) — Maximum
number of bytes that should be copied from a sampled packet.
– Counters Sampling — Enable/disable counters sampling. Flow
sampling cannot be disabled if
Flow Sampling
is disabled
–
Counters Sampling Interval (15–86400)
— If x is entered, this
specifies that a counter sample will be taken for each x seconds.
– Counters Sampling Receiver Index — Select one of the indices that
was defined in the sFlow Receivers Settings pages.
Configuring sFlow Interfaces Using the CLI Commands
The following table summarizes the CLI commands for configuring sFlow
interfaces.
The following is an example of the CLI commands:
Table 9-74. sflow Interface CLI Commands
CLI Command Description
sflow flow-sampling rate
receiver-index [ max-header-size
bytes ]
no sflow flow-sampling
Enables sFlow Flow sampling and
configure the average sampling rate
of a specific port.
Use the no form of this command to
disable Flow sampling.
sflow counters-sampling interval
receiver-index
no sflow counters-sampling
Enable sFlow counters sampling and
to configure the maximum interval of
a specific port.
Use the no form of this command to
disable sFlow Counters sampling.
console(config)# interface gi2/0/3
console(config-if)# sflow flow-sampling 1024 1