Dell PowerConnect 55xx Systems User Guide
203
All IPv6 address formats are acceptable, yet for display purposes, the system
displays the most abbreviated form, which replaces groups of zeros with
double colons and removes the leading zeros.
IPv6 Prefixes
While Unicast IPv6 addresses written with their prefix lengths are permitted,
in practice their prefix lengths are always 64 bits, and therefore are not
required to be expressed. Any prefix that is less than 64 bits is a route or
address range that summarizes a portion of the IPv6 address space.
For every assignment of an IP address to an interface, the system runs the
Duplicate Address Detection (DAD) algorithm to ensure uniqueness.
An intermediary transition mechanism is required for IPv6-only nodes to
communicate with IPv6 nodes over an IPv4 infrastructure. The tunneling
mechanism implemented is the Intra-Site Automatic Tunnel Addressing
Protocol (ISATAP). This protocol treats the IPv4 network as a virtual IPv6
local-link, with each IPv4 address mapped to a Link Local IPv6 address.
IPv4 Interface Parameters
You can assign IP addresses to the interface in the following ways:
• Manual Assignment — Described below
• DHCP Server Assignment — Described in "DHCP IPv4 Interface" on
page 207
Multiple IP addresses can be configured in the
IPv4 Interface Parameters
pages. These IP addresses can be assigned to a port, LAG, or VLAN interface.
When an IP address is assigned, it is checked for uniqueness in the following
way:
• A gratuitous ARP request is sent three times every three seconds.
• If after (3+1)*3 = 12 seconds the switch has not received the ARP
response, the IP address is considered to be unique.
• During the procedure the switch has to reply to gratuitous ARP and probe
ARP requests with the validated IP address.
Summary of Contents for POWERCONNECT 5524
Page 415: ...Dell PowerConnect 55xx Systems User Guide 415 ...
Page 728: ......
