Dell POWERCONNECT 5524, User Manual

Page: 213 / 728

Dell PowerConnect 55xx Systems User Guide
213
Configuring Two IP Networks on Two Different VLANS Using CLI
The following shows how to configure two IP networks on two different
VLANS using CLI:
To test this setup described in Figure 11-18:
1 Connect a host whose address is 1.1.1.2 to interface 1/0/1 (default route
1.1.1.1)
2 Connect a host whose address 2.1.1.2 to port 1/0/2 (default route 2.1.1.1)
3 Ping from 1.1.1.2 to 2.1.1.2 to verify the configuration
Table 9-25. Sample CLI Script to Configure Two IP Networks on Two Different VLANSs
CLI Command Description
console# config
Enter Global Configuration
mode.
console(config)# vlan database
Enter VLAN mode.
console(config-vlan)# vlan 100-150
Create VLANs number 100 to
150.
console(config-vlan)# exit
Exit VLAN mode.
console(config)# interface gi1/0/1
Enter Interface mode for port
1 on unit 1.
console(config-if)# switchport access
vlan 100
Make port a member of
VLAN 100.
console(config-if)# ip address
1.1.1.1 255.255.255.0
Set the IP address with mask.
console(config-vlan)# exit
Exit Interface mode for port.
console(config)# interface gi1/0/2
Enter Interface mode for port
2 on unit 1.
console(config-if)# switchport access
vlan 150
Make port a member of
VLAN 150.
console(config-if)# ip address
2.1.1.1 255.255.255.0
Set the IP address with mask.
console(config-vlan)# exit
Exit Interface mode for port.