Load balance
The Load Balance property provides the ability to automatically use both controller ports or connectors connected to the same
enclosure to route I/O requests. This property is available only on SAS controllers.
Bgi rate
On PERC controllers, background initialization of a redundant virtual disk begins automatically within 0 to 5 minutes after the virtual
disk is created. The background initialization of a redundant virtual disk prepares the virtual disk to maintain redundant data and
improves write performance. For example, after the background initialization of a RAID 5 virtual disk completes, the parity
information has been initialized. After the background initialization of a RAID 1 virtual disk completes, the physical disks are mirrored.
The background initialization process helps the controller identify and correct problems that may occur with the redundant data
later. In this regard, the background initialization process is similar to a check consistency. The background initialization should be
allowed to run to completion. If cancelled, the background initialization automatically restarts within 0 to 5 minutes. Some processes
such as read and write operations are possible while the background initialization is running. Other processes, such as creating a
virtual disk, cannot be run concurrently with a background initialization. These processes cause the background initialization to
cancel.
The background initialization rate, configurable between 0% and 100%, represents the percentage of the system resources
dedicated to running the background initialization task. At 0%, the background initialization has the lowest priority for the controller,
takes the most time to complete, and is the setting with the least impact to system performance. A background initialization rate of
0% does not mean that the background initialization is stopped or paused. At 100%, the background initialization is the highest
priority for the controller. The background initialization time is minimized and is the setting with the most impact to system
performance.
Check consistency
The Check Consistency task verifies the accuracy of the redundant (parity) information. This task only applies to redundant virtual
disks. When necessary, the Check Consistency task rebuilds the redundant data. If the virtual disk is in a Failed Redundancy state,
running a check consistency may be able to return the virtual disk to a Ready state.
The check consistency rate, configurable between 0% and 100%, represents the percentage of the system resources dedicated to
running the check consistency task. At 0%, the check consistency has the lowest priority for the controller, takes the most time to
complete, and is the setting with the least impact to system performance. A check consistency rate of 0% does not mean that the
check consistency is stopped or paused. At 100%, the check consistency is the highest priority for the controller. The check
consistency time is minimized and is the setting with the most impact to system performance.
Create or change security keys
When configuring the controller properties, you can create or change the security keys. The controller uses the encryption key to
lock or unlock access to SED. You can create only one encryption key for each encryption-capable controller. The security key is
managed using the Local Key Management (LKM) feature. LKM is used to generate the key ID and the password or key required to
secure the virtual disk. If you are using LKM, you must create the encryption key by providing the Security Key Identifier and the
Passphrase.
This task is not supported on PERC hardware controllers running in HBA mode.
If you create the security key-in Add to Pending Operation mode and a job is not created, and then if you delete the security key,
the create security key pending operation is cleared.
Configuring controller properties using web interface
1.
In the iDRAC web interface, go to
Overview
→
Storage
→
Controllers
→
Setup
.
The
Setup Controllers
page is displayed.
2.
In the
Configure Controller Properties
section, from the
Controller
drop-down menu, select the controller that you want to
configure.
3.
Specify the required information for the various properties.
205