2.1.9. Main Menu Mode
Start the Main Menu mode by pressing the [Main Menu] key. The read-
out shown to the right appears on the display.
The middle and bottom sections on the display show a list of parameter
groups which can be chosen by toggling the up and down buttons.
1
30BP066.10
Each parameter has a name and number which remain the same regardless of the programming mode. In the Main Menu mode, the parameters are
divided into groups. The first digit of the parameter number (from the left) indicates the parameter group number.
All parameters can be changed in the Main Menu. However, depending on the choice of configuration (par. 1-00), some parameters can be "missing".
E.g. open loop hides all the PID parameters, and other enabled options make more parameter groups visible.
2.1.10. Parameter Selection
In the Main menu mode, the parameters are divided into groups. You
select a parameter group by means of the navigation keys.
The following parameter groups are accessible:
Group no.
Parameter group:
0
Operation/Display
1
Load/Motor
2
Brakes
3
References/Ramps
4
Limits/Warnings
5
Digital In/Out
6
Analog In/Out
7
Controls
8
Comm. and Options
9
Profibus
10
CAN Fieldbus
11
Reserved Com. 1
12
Reserved Com. 2
13
Smart Logic
14
Special Functions
15
Drive Information
16
Data Readouts
17
Motor Feedb. Option
After selecting a parameter group, choose a parameter by means of the
navigation keys.
The middle section on the display shows the parameter number and name
as well as the selected parameter value.
1
30BP067.10
2.1.11. Changing Data
The procedure for changing data is the same whether you select a parameter in the Quick menu or the Main menu mode. Press [OK] to change the
selected parameter.
The procedure for changing data depends on whether the selected parameter represents a numerical data value or a text value.
FC 300 Programming Guide
2. How to Programme
MG.33.M3.02 - VLT
®
is a registered Danfoss trademark
19
2
