0
*
[0 - 9999]
View a list of the parameters that have been changed from their default setting. The list ends with 0. Changes
may not be visible until up to 30 seconds after implementation.
15-99 Parameter Metadata
Array [30]
0
*
[0 - 9999]
This parameter contains data used by the MCT10 software tool.
2.17. Parameters: Data Read-outs
2.17.1. 16-** Data Readouts
Parameter group for data read-outs, e.g. actual references, voltages, control, alarm, warning and status words.
2.17.2. 16-0* General Status
Parameters for reading the general status, e.g. the calculated reference, the active control word, status.
16-00 Control Word
Range:
Function:
0
*
[0 - FFFF]
View the Control word sent from the frequency converter via the serial communication port in hex code.
16-01 Reference [Unit]
Range:
Function:
0.000
*
[-999999.000 -
999999.000]
View the present reference value applied on impulse or analog basis in the unit resulting from the configuration
selected in par. 1-00 (Hz, Nm or RPM).
16-02 Reference %
Range:
Function:
0%
*
[-200 to 200 %]
View the total reference. The total reference is the sum of digital, analog, preset, bus, and freeze references,
plus catch-up and slow-down.
16-03 Status Word
Range:
Function:
0
*
[0 - FFFF]
View the Status word sent from the frequency converter via the serial communication port in hex code.
16-05 Main Actual Value [%]
Range:
Function:
0%
*
[-100 to +100%]
View the two-byte word sent with the Status word to the bus Master reporting the Main Actual Value.
16-09 Custom Readout
Range:
Function:
0.00 unit
*
[x.xx - x.xx unit]
View the value of custom readout from par. 0-30 to par. 0-32
2.17.3. 16-1* Motor Status
Parameters for reading the motor status values.
FC 300 Programming Guide
2. How to Programme
MG.33.M3.02 - VLT
®
is a registered Danfoss trademark
157
2
