DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
162
Timeout : 5 seconds
Retransmit : 2
Index IP Address Auth-Port Acct-Port Status Key
Number Number
----- ------------------ --------- --------- -------------- ---------------
1 10.1.1.1 1812 1813 Active switch
2 20.1.1.1 1800 1813 Active des3226
3 30.1.1.1 1812 1813 Active dlink
Total Entries : 3
DES-1228/ME:4#
create 802.1x guest_vlan
Purpose
Used to configure a pre-existing VLAN as a 802.1X Guest VLAN.
Syntax
create 802.1x guest_vlan <vlan_name 32>
Description
The
create 802.1x guest_vlan
command is used to configure a pre-defined VLAN as a
802.1X Guest VLAN. Guest 802.1X VLAN clients are those who have not been authorized
for 802.1X or they haven’t yet installed the necessary 802.1X software, yet would still like
to have limited access rights on the Switch.
Parameters
<vlan_name 32>
−
Enter an alphanumeric string of no more than 32 characters to define a
pre-existing VLAN as a 802.1X Guest VLAN. This VLAN must have first been created with
the
create vlan
command mentioned earlier in this manual.
Restrictions
Only Administrator-level users can issue this command.
Users must have already previously created a VLAN using the
create vlan
command.
Only one VLAN can be set as the 802.1X Guest VLAN.
Example usage:
To configure a previously created VLAN as an 802.1X Guest VLAN for the Switch:
DES-1228/ME:4#create 802.1x guest_vlan Trinity
Command: create 802.1x guest_vlan Trinity
Success.
DES-1228/ME:4#
config 802.1x guest_vlan ports
Purpose
Used to configure ports for a pre-existing 802.1X guest VLAN.
Syntax
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
Description
The
config 802.1x guest_vlan ports
command is used to configure ports to be enabled
or disabled for the 802.1X guest VLAN.
Parameters
<portlist>
−
Specify a port or range of ports to be configured for the 802.1X Guest VLAN.
all
– Specify this parameter to configure all ports for the 802.1X Guest VLAN.
state [enable | disable] –
Use these parameters to enable or disable port listed here as
enabled or disabled for the 802.1X Guest VLAN.
Restrictions
Only Administrator-level users can issue this command.
Users must have already previously created a VLAN using the
create vlan
command. If
