DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
64
10
N
ETWORK
M
ONITORING
C
OMMANDS
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
Parameters
show packet ports
<portlist>
show error ports
<portlist>
show utilization
[cpu | ports {<portlist>}]
clear counters
ports <portlist>
clear log
show log
index <value_list X-Y>
enable syslog
disable syslog
show syslog
create syslog host
<index 1-4> ipaddress <ipaddr> {severity [informational | warning | all] | facility [local0 |
local1 | local2 | local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number>|
state [enable | disable]
config syslog host
[all | <index 1-4>] {severity [informational | warning | all] | facility [local0 | local1 | local2 |
local3 | local4 | local5 | local6 | local7] | udp_port <udp_port_number> | ipaddress <ipaddr>
| state [enable | disable]}
delete syslog host
[<index 1-4> | all]
show syslog host
<index 1-4>
config log_save_timing
[time_interval <min 1-65535> | on_demand | log_trigger]
show log_save_timing
Each command is listed, in detail, in the following sections.
show packet ports
Purpose
Used to display statistics about the packets sent and received by the Switch.
Syntax
show packet ports <portlist>
Description
This command is used to display statistics about packets sent and received by ports
specified in the
<portlist>
.
Parameters
<portlist>
−
Specifies a port or range of ports to be displayed.
Restrictions
None.
Example usage:
To display the packets analysis for port 7 of module 2:
