DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
25
config ports
If set to normal state, the port in MDIX mode, can be connected to PC NIC using a straight
cable. If set to cross state, the port in mdi mode, can be connected to a port (in mdix
mode) on another switch through a straight cable.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To configure the speed of ports 1
−
3 to be 10 Mbps, full duplex, with learning and state enabled:
DES-1228/ME:4#config ports 1-3 speed 10_full state enable
Command: config ports 1-3 speed 10_full state enable
Success.
DES-1228/ME:4#
show ports
Purpose
Used to display the current configuration of a range of ports.
Syntax
show ports [<portlist>] {description | err_disabled}
Description
The show ports command displays the current configurations of a range of ports. No
parameters will show all ports.
Parameters
<portlist>
−
Specifies a port or range of ports to be displayed.
{description} – Adding this parameter to the show ports command indicates that a
previously entered port description will be included in the display.
err_disabled
– Use this to list disabled ports including connection status and reason for
being disabled.
Restrictions
None.