DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
186
25
T
IME AND
SNTP
C
OMMANDS
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NTP)) commands in the Command
Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command
Parameters
config sntp
{primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}(1)
show sntp
enable sntp
disable sntp
config time
<date ddmmmyyyy > <time hh:mm:ss >
config time_zone
{operator [+|-] | hour <gmt_hour 0-13> | min <minute 0-59>}(3)
config dst
[disable | repeating {s_week <start_week 1-5,last> | s_day <start_day sun-sat> | s_mth
<start_mth 1-12> | s_time <start_time hh:mm> | e_week <end_week 1-5,last> | e_day
<end_day sun-sat> | e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset
[30|60|90|120]}(9) | annual {s_date <start_date 1-31> | s_mth <start_mth 1-12> | s_time
<start_time hh:mm> | e_date <end_date 1-31> | e_mth <end_mth 1-12> | e_time
<end_time hh:mm> | offset [30|60|90|120]}(7)]
show time
Each command is listed, in detail, in the following sections.
config sntp
Purpose
Used to setup SNTP service.
Syntax
config sntp {primary <ipaddr> | secondary <ipaddr> | poll-interval <int 30-99999>}(1)
Description
Use this command to configure SNTP service from an SNTP server. SNTP must be
enabled for this command to function (See enable sntp).
Parameters
primary
−
This is the primary server from which the SNTP information will be taken.
<ipaddr>
−
The IP address of the primary server.
secondary
−
This is the secondary server the SNTP information will be taken from in the
event the primary server is unavailable.
<ipaddr>
−
The IP address for the secondary server.
poll-interval <int 30-99999>
−
This is the interval between requests for updated SNTP
information. The polling interval ranges from 30 to 99,999 seconds.
Restrictions
Only Administrator-level users can issue this command. SNTP service must be enabled
for this command to function (
enable sntp
).
Example usage:
To configure SNTP settings:
DES-1228/ME:4#config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Command: config sntp primary 10.1.1.1 secondary 10.1.1.2 poll-interval 30
Success.
DES-1228/ME:4#
