DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
102
Command
Parameters
config mgmt_pkt_priority
[default | <priority 0-7>]
show mgmt_pkt_priority
Each command is listed, in detail, in the following sections.
config bandwidth_control
Purpose
Used to configure bandwidth control on a port by-port basis.
Syntax
config bandwidth_control <portlist> {rx_rate [ no_limit | <value 64-1024000>] |
tx_rate [ no_limit | <value 64-1024000>]}(1)
Description
The
config bandwidth_control
command is used to configure bandwidth on a port by-
port basis.
Parameters
<portlist>
−
Specifies a port or range of ports to be configured.
rx_rate
−
Specifies that one of the parameters below (
no_limit
or
<value 64-1024000>
) will
be applied to the rate at which the above specified ports will be allowed to receive packets
no_limit
−
Specifies that there will be no limit on the rate of packets received by
the above specified ports.
<value 64-1024000>
−
Specifies the traffic limit, in Kbits, that the above ports will
be allowed to receive.
tx_rate
−
Specifies that one of the parameters below (
no_limit
or
<value 64-1024000>
) will
be applied to the rate at which the above specified ports will be allowed to transmit
packets.
no_limit
−
Specifies that there will be no limit on the rate of packets received by
the above specified ports.
<value 64-1024000>
−
Specifies the traffic limit, in Kbits, that the above ports will
be allowed to receive.
Restrictions
Only Administrator-level users can issue this command.
Example usage:
To configure bandwidth control:
DES-1228/ME:4#config bandwidth_control 1 rx_rate 64
Command: config bandwidth_control 1 rx_rate 64
Note: To perform precise bandwidth control, it is required to enable the flow control
to mitigate the retransmission of TCP traffic.
Success.
DES-1228/ME:4#
show bandwidth_control
Purpose
Used to display the bandwidth control table.
Syntax
show bandwidth_control {<portlist>}
Description
The
show bandwidth_control
command displays the current bandwidth control
configuration on the Switch, on a port-by-port basis.
Parameters
<portlist>
−
Specifies a port or range of ports to be viewed.
Restrictions
None.
Example usage:
