DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
251
38
LLDP
C
OMMANDS
The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
Parameters
enable lldp
disable lldp
config lldp message_tx_interval
<sec 5 - 32768 >
config lldp
message_tx_hold_multiplier
< int 2 - 10 >
config lldp tx_delay
< sec 1 - 8192 >
config lldp reinit_delay
< sec 1 - 10 >
config lldp notification_interval
<sec 5 - 3600 >
config lldp ports
[<portlist>|all] notification [enable | disable]
config lldp ports
[<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx | disable]
config lldp ports
[<portlist>|all] mgt_addr ipv4 <ipaddr> [enable | disable]
config lldp ports
[<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
config lldp ports
[<portlist>|all] dot1_tlv_pvid [enable | disable]
config lldp ports
[<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name 32> ] | vlanid
<vidlist> ] [enable | disable]
config lldp ports
[<portlist>|all] dot1_tlv_ protocol_identity[all | { eapol | lacp | gvrp | stp }]
[enable | disable]
config lldp ports
config lldp ports [<portlist>|all] dot3_tlvs [all | {mac_phy_configuration_status |
link aggregation | power_via_mdi | maximum_frame_size}] [enable | disable]
config lldp forward_message
[enable | disable]
show lldp
show lldp mgt_addr
{ipv4 <ipaddr>}
show lldp ports
{<portlist>}
show lldp local_ports
{ <portlist>} {mode [brief | normal | detailed]}
show lldp remote_ports
{<portlist>} {mode [brief | normal | detailed]}
show lldp statistics
show lldp statistics ports
{<portlist>}
Each command is listed, in detail, in the following sections.
enable lldp
Purpose
Used to enable LLDP operations on the switch.
Syntax
enable lldp
Description
This is a global control for the LLDP function.
When this function is enabled, the switch can start to transmit LLDP packets and receive
