Crane Merchant Six 180, Operator'S Manual

Page: 34 / 210

Initial Setup Merchant™ Operators’ Guide
August 2009 28 1810025
LEFT SPIRAL
COUPLER
RIGHT SPIRAL
COUPLER
AS VIEWED FROM FRONT OF TRAY
ONE POSITION
COUNTERCLOCKWISE
FROM VERTICAL
ONE POSITION
CLOCKWISE
FROM VERTICAL
PRODUCT PUSHER USAGE
The product pusher will give the top of a product an extra tilt to
help it fall into the delivery pan.
Use a product pusher in the following cases:
• The spiral has a capacity of 15, 13, or 11.
• The package is non-rigid like bagged peanuts.
The product pusher can also be used with other spiral and types
of products.
A bag of product pushers has been shipped with the merchandiser. Additional product pushers are
available from the National Vendors part department. To use a product pusher, snap it on the spiral
as shown. You can adjust the product pusher by moving it around on the spiral to achieve the best
vending results.
PREPARING THE MERCHANDISER FOR VEND-
ING "LUNCH BUCKET"
Because of the weight and shape of the package,
National Vendors recommends that this product be
vended only from the bottom tray.
To vend this product, two adjacent positions must be
coupled together.
(See “Installing a Gear” on page 21 for mechanical
coupling directions and see “Couple Motors” on
page 108 for electrical coupling directions).
The left spiral coupler should be installed one
position counterclockwise from the vertical position.
The right spiral coupler should be installed one
position clockwise from the vertical position.
Replace the current spirals with six-count spirals. These are available from the National Vendors
parts department. (See
“Removing and Installing Spirals” on page 18).
A pad can be installed in the bottom of the delivery pan to quiet and cushion product delivery.
This part is available from the National Vendors parts department.
Load "Lunch Bucket" products as shown below:
Loading Trays with Product (continued)
Proper Loading of "Lunch Bucket"
FOOD SELECTIONS
LOADED IN SPIRALS
157P0039
PRODUCT
PUSHER