Super 80 Professional – AOM
NORMAL PROCEDURES
Section 3 Page 38
Super 80 Professional – Aircraft Operating Manual
Coolsky, 2018
AFTER LANDING
AFTER LANDING – TAXI (Checklist)
With the exception of Autopilot, Autothrottle and Automatic Brake system which are normally
performed on the runway after rollout, none of the items in the After Landing checklist should
be accomplished until the aircraft is clear of the runway.
AUTOPILOT AND AUTOTHROTTLE SWITCHES .......................................................................... OFF
1.
Set the Autothrottle switch to OFF.
2.
Set the Master Autopilot switch to OFF.
LANDING LIGHTS ..................................................................................................................... OFF
3.
Turn OFF the Wing Landing lights and Nose Landing lights.
SPOILER LEVER .......................................................................................................................... RET
4.
Set the Spoiler Lever to RET.
AUTO BRAKES ........................................................................................................... OFF/DISARM
5.
Set the AUTO BRAKE Selector to OFF.
6.
Set the AUTO BRAKE ARM/DISARM switch to DISARM.
PNEU XFEED (One engine taxi) ..................................................................... R OPEN/L CLOSED
7.
For one engine taxi, open the right Pneumatic X-feed Valve handle (up) and leave the
left Pneumatic X-feed Valve handle closed (down).
FLAPS/SLATS .......................................................................................................... UP/RETRACTED
8.
Verify that the Flaps Handle is in the UP/RET position.
9.
Verify that the flaps are retracted.
10.
Verify that the slats are retracted (all lights out).
RADAR ...................................................................................................................................... OFF
11.
Set the Mode Selector switch to OFF.
TRANSPONDER ........................................................................................................................ STBY
12.
Set the Transponder Function Selector to STBY.
ANTI-SKID ................................................................................................................................. OFF
13.
The Anti-skid switch must be set to OFF before entering the ramp area.
BRAKE PRESSURE ............................................................................................................ MONITOR
14.
Check the Brake Pressure gauge. Both needles should indicate minimum above the red
band, but normally within the green band.
