Super 80 Professional – AOM
NORMAL PROCEDURES
Section 3 Page 9
Super 80 Professional – Aircraft Operating Manual
Coolsky, 2018
ENGINE ANTI-ICE..................................................................................................................... OFF
76.
Set both Engine Anti-Ice switches to OFF.
ENGINE SYNC .......................................................................................................................... OFF
77.
Set the ENG SYNC switch to OFF.
GROUND PROXIMITY WARNING SYSTEM ......................................................... TEST AND NORM
78.
Set the GPWS switch to TEST (the switch is spring loaded back to NORM).
79.
You should hear the aural alert “Whoop Whoop” followed by “Pull up” and “Glideslope”.
The GPWS FAIL light should also come on, together with…
80.
…the GPWS and BELOW G/S lights during the test.
CIRCUIT BREAKER AND STANDBY COMPASS LIGHTS............................................ AS REQUIRED
81.
Set the CKT BKR LT switch to OFF, or as required.
82.
Set the STBY COMP LT switch to OFF, or as required.
THUNDERSTORM LIGHT ............................................................................................................ OFF
83.
Set the THNDRSRM LT switch to OFF.
COCKPIT FLOOD LIGHT ........................................................................................... AS REQUIRED
84.
Set the CKPT FLOOD switch to OFF, or as required.
OVERHEAD CONSOLE LIGHTS ................................................................................ AS REQUIRED
85.
Set the OVHD CONSOLE LTS knobs to OFF, or as required.
STALL WARNING ...................................................................................................................... TEST
86.
Set the STALL TEST switch to SYS 1 (Momentary). This will test Stall Warning system 1. The stall
warning horn should sound, followed by the vocal alert “Stall”.
87.
The STALL warning light should come on (flashing), together with the PUSH TO INHIBIT light
(steady).
88.
Repeat test for system 2.
MAX SPEED WARNING ............................................................................................................ TEST
89.
Set the MAX SPD WARN TEST switch to SYS 1. Check that audio clacker sounds followed by
the vocal warning “Overspeed” is heard.
90.
Repeat test for system 2.
YAW DAMPER ........................................................................................................................... ON
91.
Set the YAW DAMP switch to ON.
92.
Check that the YAW DAMP OFF light is out.
MACH TRIM COMPENSATION ........................................................................................... NORM
93.
Set the MACH TRIM COMP switch to NORM.
94.
Check that the MACH TRIM INOP light is out.
AIR CONDITIONING ...................................................................................................... CHECKED
95.
Check cabin and cockpit temperature and adjust as necessary.