Super 80 Professional – AOM
FLIGHT MANAGEMENT
Section 15 Page 48
Super 80 Professional – Aircraft Operating Manual
Coolsky, 2018
FMS Vertical Navigation
Temporary speed restriction
•
Press FMS OVRD.
•
Use the SPD/MACH button to set the desired speed.
•
Press FMS OVRD again to deselect override mode and resume FMS target speed.
•
If speed change becomes permanent:
o
Make speed change on the appropriate FMS page (CLB, CRZ, DES).
Temporary altitude restriction
•
Set the temporary level off altitude on the Flight Guidance Control Panel.
•
Observe VNAV CAP and then VNAV LVL on the FMA when the altitude is reached.
Resuming climb/descent from temporary altitude
•
Set the new altitude on the Flight Guidance Control Panel.
•
Press the VNAV button.
Setting a speed/altitude constraint at a waypoint
•
Select the LEGS page (LEGS key).
•
Enter speed/altitude and line select it into the desired waypoint on the right side of the
page.
o
If the constraint is to cross the waypoint at a specific altitude
Enter the altitude only
o
If the constraint is to cross at or above an altitude
Enter A after altitude
o
If the constraint is to cross between two altitudes
Enter lower altitude followed by A, then enter upper altitude followed by B.
•
Execute the modified route.
•
To delete the waypoint constraint:
o
Use the DELETE key and line select to desired line. Observe AFMC computed
values appear.
o
Execute the modified route.
Setting a speed/altitude transition and restriction
•
Select the CLB or DES page.
•
Enter desired speed/altitude.
•
Execute the modified route.