Super 80 Professional – AOM
NORMAL PROCEDURES
Section 3 Page 40
Super 80 Professional – Aircraft Operating Manual
Coolsky, 2018
PARKING
PARKING (Checklist)
BRAKES .............................................................................................................................. PARKED
1.
Set the parking brake by lifting the Parking Brake Control knob.
SEAT BELT SIGN ........................................................................................................................ OFF
2.
Set the Seat Belt Sign switch to OFF.
PNEU XFEED VALVES ............................................................................................................ OPEN
3.
Make sure that both Pneumatic X-Feed Valve levers are in the OPEN (up) position.
APU OR EXTERNAL POWER....................................................................................... ESTABLISHED
4.
If the ground crew has plugged in the external electric power, the EXT PWR AVAIL light will
come on (blue). Note: In the panel, click the EXT PWR AVAIL light to simulate the ground
crew plugging in the external electric power.
5.
Connect the external electric power to the busses by setting the left and right EXT PWR
BUS switches to ON.
6.
If external electric power is connected, the APU should be turned off. Set the APU Master
switch to OFF.
7.
Set the APU AIR switch to OFF.
8.
Set the APU DOORS switch to OFF and put the guard back on.
FUEL LEVERS ............................................................................................................................. OFF
9.
Check that External power or APU power is properly connected to the busses by
observing at least one Power In Use lights before turning off the second Fuel Lever. Note:
The Power In Use lights will come on after you have shut down an engine.
10.
Set both Fuel Levers to OFF, one at a time.
11.
Verify both engines shutting down by observing the engine instruments dropping.
ANTI-COLLISION/EXTERIOR LIGHTS................................................................ OFF/AS REQUIRED
12.
Set the Anti-collision switch to OFF.
13.
Set the POS/STROBE light switch to OFF during daytime. Leave the Position Lights on at
night (POS position).
ENGINE IGNITION .................................................................................................................... OFF
14.
Set the ENG IGN switch to OFF.
FUEL PUMPS .............................................................................................................................. OFF
15.
Set all Fuel Boost Pump switches to OFF. If the APU is operating, leave the RH AFT pump
on.
EMERGENCY LIGHTS................................................................................................................ OFF
16.
Set the Emergency Lights switch to OFF.
PROBE HEAT ............................................................................................................................. OFF
17.
Rotate the METER SELECTOR AND HEAT switch to OFF.