Super 80 Professional – AOM
FLIGHT MANAGEMENT
Section 15 Page 22
Super 80 Professional – Aircraft Operating Manual
Coolsky, 2018
Legs Page (Continued)
MAP CTR STEP>
The MAP CTR STEP prompt is displayed when
the ND is in PLAN mode.
<CTR>
Appears adjacent to the waypoint around
which the ND plan mode is centered.
COMPUTED LEG LENGTH
Indicates the length in nautical miles
between waypoints. Blank for active leg.
ROUTE DATA
Displayed when on the active or modified
RTE LEGS pages and ND no in PLAN mode.
Selection displays the RTE DATA page.
SPEED/ALTITUDE
Displays airspeed and altitude constraints.
Valid entry for airspeed is 3 digits followed by
a slash mark (/).
Valid entry for Mach is decimal point
followed by either one, two, or three digit
Mach number followed by slash mark (/).
Valid entry for altitude is XXX (flight level),
FLXXX, or XXXXX (feet).
Speed constraint entries also require a
corresponding altitude constraint entry.
Small characters indicate estimates
computed by the AFMC.
Large characters indicate pilot entered or
database airspeed/altitude constraints.
Constraints can be entered and/or deleted
by the flight crew or they can be entered
automatically as part of a procedure.
If a constraint is to cross the waypoint at a
specific altitude, enter the altitude only. If a
constraint is to cross at or above a specific
altitude, enter A after the altitude. If a
constraint is to cross at or below a specific
altitude, enter B after the altitude. If a
constraint is to cross between two specific
altitudes, enter lower altitude followed by A,
then enter upper altitude followed by B
(example: 250A270B).
RTE 2 LEGS
This page is displayed after pushing the RTE 2
LEGS line select key on the RTE 1 LEGS page.
New waypoints for each leg of route 2 can
be entered on this page.
RTE 1 LEGS
Selection displays RTE 1 LEGS page.
