Super 80 Professional – AOM
NORMAL PROCEDURES
Section 3 Page 5
Super 80 Professional – Aircraft Operating Manual
Coolsky, 2018
ORIGINATION PRE-FLIGHT INSPECTION
ORIGINATION PRE-FLIGHT INSPECTION (Procedure)
The Origination Pre-Flight Inspection is accomplished on the first origination flight of the day
for the aircraft and anytime the condition of the aircraft is in doubt.
WALK-AROUND INSPECTION ...................................................................................... COMPLETE
1.
Not simulated.
COCKPIT SAFETY INSPECTION
BATTERY SWITCH ....................................................................................................................... ON
2.
Set the battery switch to the ON position.
COCKPIT LIGHTS ...................................................................................................... AS REQUIRED
3.
Set the Cockpit Flood light switch to OFF, or as required.
4.
Turn on the Center Instrument & Pedestal Digital lights.
5.
Turn on the Instrument Panel Digital lights.
6.
Turn on the Flight Guidance Control Panel Digital lights.
HYDRAULIC PANEL ............................................................................................................ CHECK
7.
Set the Transfer Pump switch to OFF.
8.
Set both Engine Pump switches to HI.
9.
Set the Auxiliary Pump switch to OFF.
GEAR HANDLE .................................................................................................................... DOWN
10.
Confirm that the gear handle is down and that all the three green gear lights are on.
CIRCUIT BREAKERS ............................................................................................................ CHECK
11.
Not simulated.
COCKPIT INITIAL PREPARATION
APU PWR and EXT PWR ........................................................................................................... OFF
12.
Set the APU PWR switch to OFF.
13.
Set the EXT PWR switch to OFF.
14.
Note: The APU PWR and EXT PWR switches on the Ground Service Elec Pwr Panel must be
OFF before connecting APU or External Power to main AC buses.
APU (When required) .......................................................................................................... START
15.
Please refer to STARTING APU Procedure guide on how to start the APU.
EMERGENCY LIGHTS.............................................................................................................. ARM
16.
Set the EMER LTS switch to ARM.
GALLEY POWER ........................................................................................................................ ON
17.
Set the Galley Power switch to ON.
