Chevrolet 2002 Monte Carlo, Owner'S Manual, Page: 112 / 387

2-48
3. Press SET located on your steering wheel and
release it.
4. Take your foot off the accelerator.
The CRUISE light on the instrument panel cluster will
come on after the cruise control has been set to the
desired speed.
Resuming a Set Speed
Suppose you set your cruise control at a desired speed
and then you apply the brake. This, of course shuts off
the cruise control. But you don’t need to reset it.
Once you’re going about
25 mph (40 km/h) or more,
press RES (Resume) on
your steering wheel. You’ll
go right back up to your
chosen speed and stay there.
Increasing Speed While Using Cruise Control
There are two ways to go to a higher speed:
D Use the accelerator pedal to get to the higher speed.
Press SET on the steering wheel, then release the
button and the accelerator pedal. You’ll now cruise
at the higher speed.
D Press ACC (Accelerate) on the steering wheel. Hold
it there until you get up to the speed you want and
then release the button. (To increase your speed in
very small amounts, press ACC briefly and then
release it. Each time you do this, your vehicle will
go about 1 mph (1.6 km/h) faster.
The accelerate feature will only work after you set
the cruise control speed by pressing SET on the
steering wheel.
Reducing Speed While Using Cruise Control
There are two ways to reduce your speed while using
cruise control:
D Press COAST on the steering wheel until you reach
the lower speed you want, then release it.
D To slow down in very small amounts, press COAST
on the steering wheel briefly. Each time you do this,
you’ll go about 1 mph (1.6 km/h) slower.