Ceyear 4041 Series, User Manual

Page: 106 / 203

Chapter VI Powe Meter Mode (Option)
94
Chapter VI Power Meter Mode (Option)
Section 1 Introduction to Typical Measurement
The Power meter of the 4041 series spectrum analyzer is carried out by using a USB power probe externally
connected to a USB interface through a USB cable. 8723XUSB power probe provided by CETI can test radio
frequency/microwave signals up to 40 GHz and carry out real average Power meter within a high dynamic range
of -60 dBm to + 20 dBm. The measurement reading is displayed on the display interface of the 4041 series USB
Power meter mode. The test block diagram is shown in Fig 6-1, and the attenuator is added as needed.
All operations in this section are based on the condition that the Power meter mode has
been selected, and will no longer be described separately hereinafter. The selection
method is as follows: [Mode]
→
[Power meter].
8723X
DUT
Attenuator
(option)
Fig 6-1 Power meter Structure Diagram
The power meter interface is shown in Fig. 6-2 (an example).
Fig 6-2 Power meter Interface Diagram
It is recommended that the 4041 series products use high performance microwave power probes with USB
CAUTION
Spectrum
Analyzer