Cattron DYNAGEN TOUGH Series TE410, User Manual

Page: 62 / 114

DynaGen
TM
TOUGH Series
TM
TE410 - EN
User Manual
62
9M02-9249-A001-EN
Revision A
Name Active Mode Description
RPM Increment Running Output is used to trigger inputs on an ECM to control
speed. See
Front Panel Speed Control section for more
information.
RPM Decrement Running Output is used to trigger inputs on an ECM to control
speed. See
Front Panel Speed Control section for more
information.
DEF Fluid Pump Running Active when DEF Fluid Level falls below the DEF Low
Level and stays active until the level rises above the DEF
High Level. See
CANbus (J1939) section for more
information.
Genset Disable Global Disables the generator during a stationary Regen on
Kubota engines (see Aftertreatment in the J1939
Reference Manual) or also during an engine idle condition
from the idle switched input. Automatic idle is ignored. If the
generator voltage is not below the under voltage setpoint in
10 seconds, the controller will shut down the engine on
“Generator Disable Failure.”
Dummy Load Running Output is controlled by the Dummy Load feature.
Breaker Trip Running Output is controlled by the Basic Alarms , IDMT and Load
Imbalance features. The Breaker Trip only reacts to over
current faults; it does not activate for other failures.
Auto Idle Warm-up, Cooldown Active at the start of delay to start until the end of warm-up
if warmup idle is enabled. Also active during cooldown if
cooldown idle is enabled. See Warm-up Idle and Cooldown
Idle in
Engine Logic . This output does not react to the Idle
switched input.
Warning Functions
Functions
Low Engine
Temperature High Engine
Temperature Low Oil Pressure Under Speed
Over Speed Low Fuel Level High Fuel Level Low Battery Voltage
High Battery Voltage Under Frequency Over Frequency AC Under Voltage
AC Over Voltage Over Current Fuel In Basin Battery Charger Fault
Configurable Warning 1 Configurable Warning 2 Auxiliary Sensor 1 Auxiliary Sensor 2
Auxiliary Sensor 3 Auxiliary Sensor 4
Name Active Mode Description
Load Imbalance Running AC current phases do not match. ( Load Imbalance )