Cattron DYNAGEN TOUGH Series TE410, User Manual

Page: 68 / 114

DynaGen
TM
TOUGH Series
TM
TE410 - EN
User Manual
68
9M02-9249-A001-EN
Revision A
5.5.3 Fuel Level
Use the following settings
’ configurations to allow the controller to read and interpret data from the fuel level
sensor.
Name Range Default Settings Description
Signal Source Disable
Port A
Port B
Port C
Port D
Disable The sensor input pin where the fuel level
switch or sender is attached
Sensor Type DAT R/33-240*
VDO R/0-180*
(custom sender)**
Close =
Open =
Close =
Open =
Close = Failure Select the sender that is connected to the
Signal Source above. If using a switch,
select the action that should occur when
the switch is active.
*These are preprogrammed into the
controller and cannot be changed.
-
DAT R/33-240 supports a Datcon
fuel level sensor of the range 33
Ω
to 180
Ω
-
VDO R/0-180 supports a VDO fuel
level sensor of the range 0
Ω to
180
Ω
DAT R/33-240 and VDO R/0-180 cannot
be used on port A. To use on port A, store
as a custom sender table using the
RapidCore Configurator software.
**A custom table created using the
RapidCore Configurator Software. The
text (custom sender) will be replaced
with the custom text you choose when
creating the sender.
+The switch must close to ground
Trim Offset -50.0 ~ 50.0% 0.0% Calibrate a sensor by using the offset to
correct errors. Only applies if Sensor Type
has been set to a sender.
Setpoints > Bypass
Time 0 ~ 90 s 30 s Amount of time to bypass warnings and
failures after engine has started.
Setpoints > Low
Warning
Disabled
1 ~ 90%
25%
Reading at which a
“Low Fuel Level”
warning occurs. Only applies if Sensor
Type has been set to a sender. Only
monitored in the Run Mode.