Cattron DYNAGEN TOUGH Series TE410, User Manual

Page: 82 / 114

DynaGen
TM
TOUGH Series
TM
TE410 - EN
User Manual
82
9M02-9249-A001-EN
Revision A
Behavior
Func.
Select Start Level Run Time Stop Level
Turn on an output when
the sensor rises above a
certain value. Turn off
output when the sensor
drops below a certain
value. Turn off the output
after a fixed time if the
stop level is not reached. Output
on High Set to value that
the sensor needs
to rise above to
turn on the
output. Set to the
desired
maximum
duration to
keep the
output on (i.e.,
this is the
timeout). Set to the value
the sensor
needs to drop
below to turn
off the output.
E -
Warnings
/
Failures
Trigger warnings and/or
failures on the sensor. Fault
Monitor N/A N/A N/A
F -
Display
only
Do not perform any
actions based on the
sensor value. Just display
the value to the user. Fault
Monitor
(Disable
all
warnings
and
failures) N/A N/A N/A
1
The user must manually stop the controller by pressing the OFF button.
2
The controller must be either
•
Powered down, or
•
A reset initiated by
o
Going from the Run Mode to the Auto or Off Mode, or
o
Changing a setting in the menu and exiting the menu system
5.5.6.1 Fault Monitor Example
In this example, a sensor is monitoring the temperature of an engine block. If the temperature rises above
275 °F, a warning message is displayed. If the temperature rises above 350 °F, the engine shuts down and a
failure message is displayed.
Relevant Settings
Setting Value
Signal Source Same as Engine Temperature
Display Disable (if enabled, controller will display Engine Temperature twice)
Sensor Type Same as Engine Temperature
Sensor Table Name Engine Temp.
Active Range Running
Mode Select Fault Monitor
Setpoints > Low Warning Disabled