Sett
ing Page
4
119
Configuring Detection Criteria ([Detection Conditions] Tab)
Detection criteria is controlled and set in the video display area for each type of detection.
Settings Common to Each Detection Type
(1)
[Detection Settings Name (within 64 half-width alphanumeric characters)]
Enter a detection name. Be sure to enter a name in [Detection Settings Name (within 64 half-width alphanumeric
characters)].
(2)
[Area Shape]
Configure whether the detection area is a rectangle or a free-shape polygon.
Note
You cannot select [Area Shape] for camera tampering detection.
Using [Rectangular]
Configure the detection area by moving, resizing or changing the shape of the rectangle that is shown in the
video display area.
Drag the area to move it, and drag the vertices to resize it.
Using [Polygonal]
Click the video display area to place a vertex for the polygon at the clicked position.
Place the vertices in order, then either click the first vertex again or double-click the last vertex to set the polygon
detection area.
Important
• Make sure to check the video display area to see whether the detection area and non-detection area are unintentionally
overlapped.
• If you set the detection area and non-detection area close to each other, detection may be performed incorrectly.
Important
It is recommended that you configure the detection criteria in conditions as close as possible to the actual conditions in which you will
use the camera.
(1)
(2)
(3)
