Can-Am Spyder RT 2019, Operator'S Manual

Page: 115 / 187

MAINTENANCE PROCEDURES
Engine Coolant
Recommended Engine Coolant
NOTICE
Always use ethylene-gly-
col antifreeze containing corrosion
inhibitors specifically for internal
combustion aluminum engines.
To prevent antifreeze deterioration, al-
ways use the same brand and grade.
Never mix different brands or grades
unless cooling system is completely
flushed and refilled.
Scandinavia Countries
XPS™ RECOMMENDED COOLANT
EXTENDED LIFE PRE-MIXED
COOLANT (EUR) (P/N 779223)
If THE RECOMMENDED XPS
COOLANT IS NOT AVAILABLE
Use a low silicate, extended life
ethylene-glycol premixed coolant
(50%-50%) specifically formulated for
internal combustion aluminum engines.
All Other Countries
XPS™ RECOMMENDED COOLANT
EXTENDED LIFE PRE-MIXED
COOLANT (P/N 779150)
If THE RECOMMENDED XPS
COOLANT IS NOT AVAILABLE
Use a low silicate, extended life
ethylene-glycol premixed coolant
(50%-50%) specifically formulated for
internal combustion aluminum engines.
Verifying the Engine Coolant Level
WARNING
When opening the reservoir, the
coolant can be very hot and spray
out if the engine is hot. In order
to avoid getting burned, check the
coolant level when the engine is
cold.
With the engine cold, check the
coolant level as follows:
1. Park the vehicle on a firm, level sur-
face.
2. Open the front storage compart-
ment cover.
3. Remove the plastic rivet from the
right service cover.
rmr2010-038-021_a
1. Right service cover
2. Plastic rivet
4. Pull down the service cover using
the recess to release upper tabs
from the front fascia.
rmr2010-038-061_a
5. Pull out the rear tab.
6. Lift service cover to remove it.
NOTICE
Pay attention not to dam-
age the front storage switch.
7. Check the coolant level on the right
hand side. Coolant must be visible
slightly above the COLD level mark.
NOTE: If engine is hot, coolant must
be visible without exceeding the HOT
level mark.
______________
113