Can-Am Spyder RT 2019, Operator'S Manual

Page: 111 / 187

MAINTENANCE PROCEDURES
NOTICE
Adjusting the oil level on
a cold engine will result in overfill-
ing.
1. Take a ride of at least 15 km (9 mi).
2. Park the vehicle on a level surface
and apply the parking brake.
3. Let the engine idle for 10 minutes at
least 20 seconds.
WARNING
Exhaust gas contains poisonous
carbon monoxide that can rapidly
accumulate in an enclosed or
poorly ventilated area. If inhaled,
it can cause serious injury or
death. Only run the engine in an
unenclosed, well ventilated area.
NOTICE
Adjusting the oil level on
a cold engine will result in overfill-
ing.
4. Stop engine.
NOTE: Engine oil level verification
must be performed within 2 minutes
after engine stop.
5. Open the seat. Refer to OPENING
THE SEAT in EQUIPMENT .
6. Unscrew and remove the oil dip-
stick.
rmo2014-005-015_a
1. Oil dipstick
2. Oil filler tube
7. Wipe off the dipstick.
8. Reinsert and completely screw in
the dipstick.
9. Unscrew and remove the dipstick
again.
10. Check the engine oil level on the
dipstick. It should be near or equal
to the upper mark.
rmr2014-011-080_a
1. MAX
2. MIN
3. Operating range, 0.5 L (.5 qt (U.S. liq.))
Oil Level between Lower (MIN) and
Upper (MAX) Marks:
1. Do not add oil.
2. Properly insert and tighten dipstick.
3. Close the seat.
Oil Level under MIN Mark
Adjustment:
1. Add approximately 500 ml
(17 U.S. oz) of recommended
oil.
NOTE: The oil quantity between MIN
and MAX marks is 500 ml (17 U.S. oz).
2. Restart the engine and let it idle for
10 minutes.
WARNING
Exhaust gas contains poisonous
carbon monoxide that can rapidly
accumulate in an enclosed or
poorly ventilated area. If inhaled,
it can cause serious injury or
death. Only run the engine in an
unenclosed, well ventilated area.
______________
109