MAINTENANCE PROCEDURES
rmr2014-011-081_a
1. Oil filter cover
2. O-rings
3. Oil filter
13. Allow sufficient time for oil to com-
pletely drain from clutch cover.
14. Check and clean oil filter cavity for
dirt and contamination.
15. Clean the magnet on the magnetic
drain plug.
16. Using
NEW
sealing washers and
O-rings and install both drain plugs.
NOTICE
Never reuse the drain
plug sealing washers and O-rings.
Always replace it with a new one.
17. Tighten drain plugs as specified.
TIGHTENING TORQUE
Drain plug
(oil sump cover)
28 N•m ± 2 N•m
(21 lbf•ft ± 1 lbf•ft)
TIGHTENING TORQUE
Magnetic drain
plug (clutch cover)
20 N•m ± 1 N•m
(15 lbf•ft ± 1 lbf•ft)
18. Insert
NEW
engine oil filter.
19. Install
NEW
O-rings on oil filter
cover.
20. Install oil filter cover and tighten to
specification.
TIGHTENING TORQUE
Oil filter cover
25 N•m ± 3 N•m
(18 lbf•ft ± 2 lbf•ft)
21. Pour following amount of the rec-
ommended oil into the oil tank.
OIL QUANTITIES
MODEL
WHEN
DOING...
QUANTITY
Engine oil
and engine
oil filter
replacement
5.2 L
(5.5 qt (U.S. liq.))
SE6
Engine oil,
engine
oil filter
and HCM
surface
filter
replacement
5.4 L
(5.7 qt (U.S. liq.))
22. Reinsert and completely screw in
the dipstick.
23. Check engine oil level. Refer to
ENGINE OIL LEVEL VERIFICA-
TION
in this section.
NOTICE
Ensure oil pressure warn-
ing lamp goes out within 5 seconds
from engine start. If oil pressure
warning lamp stays ON for more
than 5 seconds, STOP ENGINE and
recheck oil level.
24. Ensure engine oil filter cover, mag-
netic drain plug (clutch cover) and
drain plug (oil sump cover) are not
leaking.
25. Stop engine.
NOTE:
The oil level dipstick is accurate
when the oil temperature is between
80°C and 95°C (176°F and 203°F).
NOTE:
The quantity between MIN
and MAX marks on oil dip stick is 0.5 L
(.5 qt (U.S. liq.)).
26. Check oil level immediately and ad-
just if required. Refer to
ENGINE
OIL LEVEL VERIFICATION
in this
section
27. Reinstall all removed body panels.
28. Dispose of used oil as per your lo-
cal environmental regulations.
______________
111
Summary of Contents for Spyder RT 2019
