Can-Am Spyder RT 2019, Operator'S Manual

Page: 118 / 187

MAINTENANCE PROCEDURES
Drive Belt
Visually inspect belt alignment and
condition before each ride.
Belt alignment and deflection adjust-
ment should always be performed by
an authorized Can-Am On-Road dealer
according
to the
MAINTENANCE
SCHEDULE
.
Drive Belt Alignment
. If belt goes beyond the outside edge
of sprocket, have the belt properly
aligned by an authorized Can-Am On
-Road dealer as soon as possible.
NOTE: Belt must NOT be in contact
with flange from FRONT SPROCKET .
219001702-001_a
TYPICAL
1. Front sprocket
2. Rear sprocket
219001702-002_a
TYPICAL - FRONT SPROCKET
1. Front sprocket teeth
2. Belt
3. Sprocket flange
4. Gap between flange and belt
Drive Belt Wear
Inspect the drive belt with the vehicle
in neutral, engine off, on a level surface
with plenty of room — you will have to
roll the vehicle forward or backward to
see the full length of the belt.
rmo2008-001-109_a
DRIVE BELT SURFACES
1. Outer surface
2. Teeth side surface
3. Tooth
Inspect for the following conditions:
WEAR CONDITION
REQUIRED
ACTION
Good condition
None
Hairline cracks
Monitor
condition
Minor chipping
Monitor
condition
Opened cracks
Replace belt
Hook wear
Replace belt
Missing teeth
Replace belt
116
______________