Can-Am Spyder RT 2019, Operator'S Manual

Page: 125 / 187

MAINTENANCE PROCEDURES
rbl2015-005-002_a
LH SIDE SHOWN
1. High Beam Horizontal Adjustment Knob
"HB
H
"
2. High Beam Vertical Adjustment Knob "HB
V
"
3. Low Beam Vertical Adjustment Knob "LB"
All Models
HEADLIGHT BEAM ADJUSTMENT
Raise beam Turn knob clockwise
Lower beam
Turn knob
counterclockwise
3. Reinstall side panels. Refer to
BODY PANELS in EQUIPMENT .
Headlights Horizontal Aiming
Adjustment, High Beams (Japanese
Models Only)
If high beam headlights are out of ad-
justment (to far left or right), carry out
the following procedure.
1. Remove both middle side panels.
2. To adjust headlight beam, turn the
applicable adjustment knob.
rbl2015-005-002_a
LH SIDE SHOWN
1. High Beam Horizontal Adjustment Knob
"HB
H
"
2. High Beam Vertical Adjustment Knob "HB
V
"
3. Low Beam Vertical Adjustment Knob "LB"
Adjust both high beam headlights so
that a line drawn from the center of the
focus point (brightest spot on the wall)
to the center of the headlight assembly
is parallel to the fore and aft center line
of the vehicle.
1
B
2
3
C C
A
rbl2015-005-006_a
HIGH BEAM HEADLIGHT REFLECTION ON
TEST SURFACE (BOTH HEADLIGHTS)
1. Ground
2. Focus point
3. Vehicle center line
A. 703 mm (27-11/16 in) above ground
B. 773 mm (30-7/16 in) above ground
C. 122 mm ± 35 mm (4-13/16 in ± 1-3/8 in)
from vehicle center line
______________
123