Can-Am Spyder RT 2019, Operator'S Manual

Page: 138 / 187

HOW TO REPLACE FUSES AND LIGHTS
Right JCase Fuse Box
JCASE
FUSE NO.
DESCRIPTION RATING
1 Cooling fan 30 A
2 Accessories 40 A
3 TCM solenoids 20 A
4 LO headlamps 30 A
5
HI headlamps 20 A
Replacing a Fuse
1. To access the fuses, refer to FUSE
LOCATIONS
in
FUSES
.
2. Set the ignition switch to OFF.
3. Pull the fuse out.
4. Check whether the filament is
melted.
rmo2008-001-060_a
FUSE
1. Good fuse
2. Blown fuse
3. Melted filament
5. Replace the fuse with one with the
same rating. Spare fuses are lo-
cated in the fuse box cover.
WARNING
Using a higher-rated fuse can
cause severe damage and may
cause fire.
6. To close the fuse box covers, po-
sition covers over fuse boxes and
carefully push down until they click.
7. Zip up the liner if applicable.
8. To close the fuse service covers, po-
sition covers over fuse boxes and
push down carefully until the fuse
service covers engage.
9. Close the access cover and then the
front storage compartment.
Lights
NOTE: The front turn signal lights
and the brake lights are built with
LEDs (light emitting diode) and this
technology proved to be reliable. In
the unlikely event they do not work,
have them checked by an authorized
Can-Am On-Road dealer.
If a light described here stop working
on the vehicle, replace bulb of defec-
tive light. The lights not described here
should be serviced by an authorized
Can-Am On-Road dealer.
If the light failure still occurs, have
the vehicle serviced by an authorized
Can-Am On-Road dealer.
CAUTION Always turn the ig-
nition switch to the OFF position be-
fore replacing a bulb to avoid electric
shock.
Always check light operation after re-
placement.
136
______________