Can-Am Spyder RT 2019, Operator'S Manual

Page: 122 / 187

MAINTENANCE PROCEDURES
3. Reinstall filler cap and lock in place.
4. Close the seat and ensure it is fully
latched.
Verifying the Brake System
The front and rear brakes are hy-
draulic disc types. These brakes are
self-adjusting and do not require ad-
justment.
The brake pedal also requires no ad-
justment.
To keep brakes in good condition,
check the following as per the
MAIN-
TENANCE SCHEDULE
:
– Entire brake system for fluid leaks
– Brake pedal for spongy feel
– Brake discs for excessive wear and
surface condition
– Brake pads for wear, damage or
looseness.
RT Limited
1. Release the latch underneath the
floorboard.
2. Pivot the floorboard by manually
pushing down its front part.
3. Flip back the floorboard until it
latches. The mechanism must
work freely.
See an authorized Can-Am On-Road
dealer if there are any problems with
the brake system.
Headlights
Verifying the Headlights Aiming
(North American Models)
1. Verify tires are correctly inflated.
Refer to SPECIFICATIONS .
2. Set the rear suspension air pressure
to 0 kPa (0 PSI) using the schrader
valve located under the seat.
rmo2016-006-007_b
1. Schrader valve
3. Position vehicle in front of a test sur-
face as shown. Make sure vehicle is
on leveled ground.
rmo2010-001-007_b
A. 10 m (33 ft)
90°
rmo2010-001-008_a
Trace 2 lines parallel to the ground on
the test surface as follows:
LINES ON THE TEST SURFACE
Line A
703 mm (27-11/16 in)
above ground
Line B
773 mm (30-7/16 in)
above ground
4. Select low beam.
5. Beam aiming is correct when the
top line of the headlight reflection is
between lines A and B.
120
______________