Can-Am Spyder RT 2019, Operator'S Manual

Page: 49 / 187

BASIC PROCEDURES
7. Release the parking brake. Make
sure the brake indicator lamp on the
multifunction gauge is off.
Stopping the Engine
1. Shift into neutral.
2. Set the engine stop switch to OFF.
3. Engage the parking brake. The
brake indicator lamp will flash.
4. Turn the key to OFF.
NOTE: If the parking brake is not en-
gaged while the key is OFF, the parking
brake indicator lamp will flash and a
beeper will sound.
5. Before dismounting, check that the
parking brake is fully engaged. Rock
the vehicle back and forth.
WARNING
Always engage the parking brake.
The vehicle can roll if the parking
brake is not engaged, regardless
of what gear it is in. The clutch is
always disengaged when the vehi-
cle is stopped, so the transmission
will not hold the vehicle in place.
This vehicle is equipped with an Elec-
tronic Throttle Control (ETC).
Pushing the Vehicle
NOTE: Before pushing the vehicle, en-
sure the ignition key is in the ON posi-
tion.
CAUTION Avoid pushing the
vehicle on a slope. If you must push
the vehicle on a slope, take extra
care to stay within reach of the brake
pedal in case the vehicle starts to
roll.
To move the vehicle a short distance
without starting the engine:
1. While seated on the vehicle, push
down and hold the brake pedal.
2. Disengage the parking brake.
3. Dismount on the right side of the ve-
hicle, keeping your foot on the brake
pedal.
4. Push the vehicle, using the brake as
needed.
CAUTION Only push from the
right side, so you can reach the brake
pedal. Stay clear of the hot exhaust
pipe.
When pulling the vehicle backward,
be careful that the front wheel does
not roll over your feet.
5. Remount the vehicle and park as
specified above.
Operating in Reverse
For safe operation in reverse, refer to
SAFE OPERATING INSTRUCTIONS
section.
Shifting Into Reverse
1. With engine running, the vehicle
stopped, and the brake depressed,
shift into first gear or neutral.
2. Press and hold the reverse button.
3. Pull the gearshift selector toward
you to downshift to reverse.
Driving in Reverse
Check that the area behind you is clear
and continue to look backwards while
you operate in reverse. Keep your
speed low and do not back up for long
distances.
Shifting Out of Reverse
To shift out of reverse, stop vehicle and
push on upshift selector quickly to shift
into neutral and more longer to shift in
first gear.
NOTE: To shift out of reverse into 1st
gear, press the brake pedal and shift
up.
Operation During Break-In
A break-in period of 1 000 km (600 mi)
is required for the vehicle.
_______________
47