CADDX xGenConnect, Installation And Programming Manual

Page: 34 / 166

22 xGenConnect Installation and Programming Guide
NXG-4 Wiring Diagram
Refer to “NXG-8(E) Wiring Diagram” on
page 17. The NXG-4 unit functionality is the
same as NXG-8 except that the connections
are spatially orientated differently.
NXG-4 Terminals
Refer to “NXG-8(E) Terminals” on page 19.
The NXG-4 unit functionality is the same as NXG-8 except it provides two
additional connections:
• Antenna 1: After the board is installed in the metal enclosure, insert the
antenna with the corresponding icon.
• Antenna 2: After the board is installed in the metal enclosure, insert the
antenna with the corresponding icon.
Caution: Removing one or both antennas will cause the panel to report a panel
housing tamper.
NXG-4 LEDs
Refer to “NXG-8(E) LEDs” on page 20.
The NXG-4 unit functionality is the same as NXG-8 except it has the following
additional LED:
• D5 RF: Red LED blinks when message is sent or received from a 63bit /
80plus transmitter.
LAN-
OUTPUT 2-
OUTPUT 3-
ZONE 1
COM
ZONE 3
ZONE 4
AUX+
COM
POS
COM
DATA
BELL-
AC
AC
EARTH
POS
NEG
LAN+
OUTPUT 1-
ZONE 2
RF
TERM
LINK
J14
USBUP TAMPER
LEARN
ULTRASYNC
LAN
+ RED
-BLACK
12V 4AH
BATTERY
J11
BUS
ANT 2 ANT 1